HOBBY: Magnetizing Flight Stands Like a Pro
Are you sick of your skimmers always falling of their bases, or drooping onto the table? Time to magnetize your flight stands!
It’s actually pretty easy AND affordable to magnetize a whole army’s worth of skimmers all in one go, and I’ll show you how.
All you need are some 1/4″ x 1/16 magnets, an accompanying drill bit, the normal flying stand with stem, and some 1/4″ diameter tubing (for this project I just used the Gale Force Nine Accessory Pack cause I’m lazy)
The first and foremost trick to make this work, is to take some wide packing tape and cover the bottom of the base that will touch the table top. As you add the tubing, magnets, and such the chemical processes of the glue and added weigh of the whole new assembly tends to cause the flight stands to crack right down the middle, unless you secure it with a square patch of tape first.
Trust me I learned the hard way, do this first. 🙂
After secure all your bases, it’s time to grab a section of tubing and make some measurements. You just want to measure one piece out, then duplicate it’s size by marking its width on the rest of the tubing you have.
Just measure out how high your flight stand is, and then add 1/16″ to the total. That way the magnet will sit on top of the plastic stem (giving it strength), and be flush with the top of your tube so it mates to the magnet you’ll put into the skimmer itself.
After you make your measurement of how big of a tube you’ll need, duplicate that part until you have enough tubing for your fleet of skimmers.
Cut out all you pieces using a straight edge, and try to be as precise as possible. Only make clean cuts, you don’t want your skimmer to sag because you didn’t cut the tube straight across!
Then glue down the tubing to the flying base, and attach the magnet on top of the plastic stem that’s now inside the tubing. Make sure that the magnet drys flush with the top of the tubing straight across!
Now drill a hole a little bit deeper than 1/16″ into whatever model you want to attach to the flight stand. Then after checking the polarity of the magnet on the stem, glue the same sized magnet into the skimmer flush making sure that it will attract (not repel) the magnet in the stem.
Now all that’s left is to paint the flying base, if that’s your preference, and play some games!!!
I hope this article helps you with your skimmers! -MBG
Latest News From BoLS:
- Critical Role’s ‘Exandria Unlimited: Calamity’ Begins Tonight
- Minis Spotlight: Massive 40k Kitbash, Elegant Flower Knight, and Cheering Snotling
- J.J. Abrams Taking on Live-Action ‘Speed Racer’ Series for Apple TV+
- 40K Grimdark Theories: Is The Emperor Wide Awake?
- Warhammer 40K: 30 Years Of Plague Marines